Dexter Laundry T-600 (30-Cycle) - Manual (Page 11)

11
OPERATING INSTRUCTIONS
1.
Ensure that power is on to the washer.
2.
Ensure that the ADVANCE/RUN/PROGRAM keylock is in the RUN position.
3.
Load the clothes loosely in the cylinder and latch the door securely. Be
sure clothing does not get caught between the door gasket and tub front
when closing the door.
NOTE: To begin closing the door, the handle must be in the horizontal
position. After moving the door to the closed position, the
handle must be turned down to the vertical position in order
to latch the door for machine operation.
4.
Select one of thirty cycles by using the SCROLL UP/SCROLL DOWN buttons to
change the number indicated in the two digit LED display. The selection
is made when the number indicated corresponds with the desired cycle.
5.
If you are manually adding wash compounds, add low sudsing powdered
detergent in the amount shown below into the detergent compartment on top
of the machine. Location is illustrated on the black cover on the top of
the machine. This compartment will be flushed during the WASH segment of
the cycle. Rinse conditioners may be added to their own compartment if
desired. This compartment will be flushed during the FINAL RINSE segment
of the cycle.
POWERED
DETERGENT REQUIREMENT
THOROUGHBRED 600 1/3 to 1/2 CUP
Figure 8 - Recommended Detergent Quantity
6.
If you wish to manually add bleach during the cycle, add bleach in the
round opening in the top of the machine. Location is illustrated on the
black cover on the top of the machine.
NOTE: Any additional washing compounds may be added at the appropriate
time by pouring into the round opening in the top.
7.
Push the green START button to start the cycle.
The cycle time remaining is displayed throughout the cycle. The cycle
number in operation can to displayed by pushing and holding START, then
push SCROLL UP. The cycle number will be displayed as long as these two
buttons are depressed.
Soak - At any time during the cycle, the red STOP button can be depressed
to stop the washer. All washer cycle information is retained and the
door remains locked. The washer will soak the load for 15 minutes, then
agitate for 30 seconds. This will repeat until the cycle is started
again. This feature allows for an extended soak if required. The washer
cycle will continue when the START button is depressed.
The selected cycle can be cleared at any time by depressing and holding