Dexter Laundry T-30X2 EXPRESS - Electric (On-Premise) User Manual
Page 20
-20-
2) Press and release the PROG touch pad key on the dryer controller. The dryer controller
display will not change.
3) Immediately, press and release the UP arrow key on the dryer controller touch pad. The
controller display will change from “LOAd” to “Prog”. You have now entered the permanent
programming mode. The dry time L.E.D. will remain on and the programming L.E.D. will
illuminate.
4) Press and release the SELECT/ENTER touch pad key once. The dry time L.E.D. and
programming L.E.D. will remain on and the dry time L.E.D. will illuminate. The dryer
controller will also show the number “35”.
5) Press the UP arrow touch pad key 18 times until the dryer controller display shows the number
“53”.
6) Press and release the SELECT/ENTER touch pad key once. The dry time L.E.D. and
programming L.E.D. will remain on and the dry time L.E.D. will switch off. The temperature
L.E.D. will illuminate and the dryer controller display will show the number “180”.
7) Press and release the UP arrow touch pad key three times until the dryer controller display
shows the number “195”.
8) Press and release the SELECT/ENTER touch pad key. The dry time L.E.D. and the
programming L.E.D. will remain on and the temperature L.E.D. will switch off. The cool
down L.E.D. will illuminate and the dryer controller display will show the number “5”.
9) Press and release the DOWN arrow touch pad key twice until the dryer controller display
shows the number “3”.
10) Press and release the SELECT/ENTER touch pad key. The dry time L.E.D. and the
programming L.E.D. will remain on and the cool down L.E.D. will switch off. The dryer
controller display will change to “Prog”.
11) Press and release the STOP touch pad key. The dry time L.E.D. will remain on and the
programming L.E.D. will switch off. The dryer controller display will change to the word
“LOAd”.
The dryer is now ready for the new modified dry cycle to start. This modified dry cycle 1 program will
remain in the dryer controller memory until the default settings push button is pressed. This default
settings push button is located on the component side of the dryer controller printed circuit board at the
middle center side of each circuit board controls.