Dexter Laundry T-30X2 EXPRESS - Electric (On-Premise) - Manual (Page 17)

-17-
PROCEDURE
1)
After the load has been placed in the dryer, press and release the UP or DOWN touch pad key on
the dryer controller until the L.E.D. for dry cycle 1 is illuminated.
2) Press and release the CYCLE key on the dryer controller touch pad. You will see the number
“35” on the dryer controller display. The programming L.E.D. and dry time L.E.D. will be
illuminated.
3)
Press and release the UP arrow key on the dryer controller touch pad 10 times so the display will
show a flashing “45”. When the UP arrow touch pad key is pressed the first time, the number “36”
will be flashing on the dryer controller display. Each number after that will also flash.
4)
Now, press and release the SELECT/ENTER touch pad key on the dryer controller. The number
“45” will stop flashing and the dry time L.E.D. will switch off. The dryer controller display will now
show “180”, the temperature L.E.D. will illuminate, and the programming L.E.D. and dry cycle 1
L.E.D. will remain on.
5)
Press and release the UP arrow key on the dryer controller touch pad one time so the controller
display will show a flashing “185”. Each press of the UP arrow key will increment the temperature by
five degrees.
6)
Now, press and release the SELECT/ENTER touch pad key on the dryer controller. The number
“185” will stop flashing and the temperature L.E.D. will switch off. The dryer control display will
now show a number “5”, the cool down L.E.D. will illuminate, and the programming L.E.D. and dry
cycle 1 L.E.D. will remain on.
7)
Press and release the SELECT/ENTER key on the dryer controller touch pad, since the desired
cool down time is five minutes. After you press the SELECT/ENTER touch pad key on the controller,
the cool down L.E.D. and programming L.E.D. will switch off. The controller display will remain at
“5” and the cycle 1 L.E.D. will remain on.
You are now ready to start the new dry cycle. This new dry cycle will be in effect for one dry cycle only.
After the dry cycle is done, or if the STOP touch pad key on the dryer controller is pressed and released
twice, consecutively, the cycle 1 program will revert to the factory default settings.
If you press the START touch pad key on the dryer controller, the controller display will change from the
number “5” to the number “45” and dry cycle 1 will begin.