Dowco Power Sports Guardian ATV Cover - Manual

Installation
Carefully read the instructions before initial installation.
Unfold cover. Locate the “FRONT” tag at the front
of the cover. Position the cover on top of the unit.
Carefully pull over handlebars, racks, etc. The
cover is designed to reach over most front/rear rack
combinations and cover most of the wheels. The
elastic hem should pull the cover tightly around the
wheels.
Caution: Mirrors, foot pegs, muffler ends, etc. are
common wear points. Do not allow fabric to "snag"
around them.
Care and Cleaning
Your cover requires very little maintenance. Normal
dirt and grime should be brushed off with a soft terry
cloth or removed with warm water using a sponge
or terry cloth.
Caution: Do not use detergents or wash in a
clothes washing machine. Do not use a clothes
dryer.
The cover should be thoroughly dried before using
or long term storage while folded.
A water-repellant spray material, such as 3M
Scotchguard
® is recommended for increased water
resistance.
Although treated with UV inhibitors, the fabric may
fade in direct sunlight after continuous use. This is
normal wear.
Important
Failure to comply with the above direction may
reduce the life of your cover. If you have any ques-
tions or comments, please contact your dealer or
DOWCO, Inc.
Congratulations on your purchase of a Guardian ® ATV cover. Properly cared for, your cover will last for
many years of service. Your cover is manufactured from water resistant 100% nylon and may be used
either inside or outdoors. Your cover also contains an elastic shock cord that is sewn into the hem. This
feature keeps the cover tight around your ATV. The following information should be used to ensure max-
imum longivity:
NOTE: This cover is designed for a variety of ATV's. If you are uncertain that your cover is fitting prop-
erly, please contact your dealer or Guardian
® to verify your fit before attempting first-time use.
This cover is not designed to cover your ATV while trailering. You will void your Warranty.
INSTRUCTIONS FOR THE INSTALLATION OF AN ATV COVER
This cover must be completely removed prior to starting
or operating the vehicle. Failure to do so could result in
serious injury and/or property damage.
Item: 00350
Revised 04/04
Printed in China
4230 Clipper Drive Manitowoc, WI 54220 U.S.A.
Phone: (800) 558-7755 - Fax: (920) 682-5891 - Email: [email protected]
Visit our Web Site! - www.dowco-inc.com