Swanstone SD-A38NEO with alcove walls - Installation - Manual (Page 3)

3
STEP 1
Positioning Wall Jambs
Fig. 1
Fig. 2
Reposition Wall Jambs (A) against shower walls. Re-
align the Wall Jamb holes with the installation holes
drilled in the shower walls. Secure each Wall Jamb (A)
with three (3) #8 x 3/4" pan head screws (E). Lift Side Panel (B) onto base ledge and slide Panel
Expander Jamb over Wall Jamb (A). Insure that
Expander Jamb adjustment holes are toward the interior
of the shower. Repeat step for other side.
Fig. 3
Determine the curb centerline, then offset and mark a line
5/8 of an inch toward the outside of shower as shown in
figure 1.
Separate the Wall Jambs (A) from their respective End
Panels (B) as shown in exploded view.
Position Wall Jambs (A) up against shower walls . . .
aligning their outside legs with the offset mark previously
marked on base ledge.
Use a level to plumb Wall Jambs (A). Then using a felt tip
pen, make a mark on the shower walls thru each of the
three (3) installation holes. Remove Wall Jambs (A) and
lightly center punch installation hole locations.
Drill 1" deep installation holes in the locations previously
marked. Use a 3/16" masonry bit when drilling thru ceramic
tile, marble or any masonry type surface and insert Plastic
Screw Anchors (D).
STEP 3
Installing Side Panels STEP 2
Installing Wall Jambs