Swanstone ULAD-1913 - Installation - Manual (Page 5)

General Tools
2-1/2 hp router (such as Porter Cable 7539).
Drill or cordless drill (such as DeWalt DCD940KX 18V
Variable Speed Reversible Driver Drill).
Orbital sander (such as Dynabug pneumatic sander).
Tungsten carbide grit hole saw (1-1/2 to 2 inch
diameter).
36 grit, 60 grit, 120 grit, 220 grit, and 320 grit
sandpaper pads to fit orbital sander. (Scotchbrite
pads may be used instead of 320 grit sandpaper, if
desired).
Deep throat locking plier clamps (such as Vise Grip
DR18 Locking Clamp).
Flexible putty knife.
Clean cloths.
Denatured alcohol.
Swanstone Part Numbers:
VW 00020-000 — Round-over bit (1/2 inch radius)
VW 00010-000 — Bevel bit (12 degrees)
VW 0050-000 — Special countersink drill bit
VW 10030-001 — Tungsten router cutting bit
Disclaimer
The photos shown in the instructions may be
different from the actual sink being installed;
however, the installation method is the same.
The information contained in this manual is given free
of charge. It is based upon technical data which we
believe to be reliable and is intended for use by
persons having knowledge of this technical area, at
their own discretion and risk. Swan Corporation
assumes no responsibility for results obtained or
damage incurred from the use of this material either
in whole or in part by the buyer.
This manual will give you basic instructions for the
installation of the product in a step-by-step sequence
that will work in most types of installations. If you
have an installation application that is not covered in
this manual, please call your local Swan Corporation
distributor or contact The Swan Corporation directly
for additional information about your application.
Follow all installation instructions. Failure to follow
these instructions could result in personal injuries or
damage to tools, cabinets, vanities, floors, or other
portions of the building or home.
800-325-7008 5 The Swan Corporation
General Information