Swanstone ULAD-1913 - Installation - Manual (Page 3)

IMPORTANT NOTICE: Indicates that equipment or
property damage can result if instructions are not
followed.
Read and Understand the Manual
It is the responsibility of any individual who
installs or maintains this product to fully
understand and follow proper installation and
maintenance procedures. Be aware of the inherent
dangers in the use of power tools when installing this
product. Read and understand all Warnings, Cautions,
and Important Notices in this manual.
Work Safely
DO NOT proceed if any doubt arises about the
correct or safe method of performing anything
found in this or other Swan Corporation
manuals. The installation of this product can require
using power tools. Do not use power tools without
adequate training. If necessary, hire or consult a trained
professional for expert assistance before continuing.
Use Proper Tools
Always use proper tools which are in good,
working condition during the installation of the
Swan Corporation products. Using tools,
other than those listed, could adversely affect the
integrity of this product and could result in water damage
or other damage to floors, pipes, walls, or other portions
of the building or home.
Use Proper Adhesives and Hardware
Only use the appropriate color-matched acrylic
glue to bond this product. Only use approved
screws and hardware when bonding
Swanstone components. Never use nails or unapproved
screws that could adversely affect the integrity of this
product.
CAUTION: Indicates a potentially hazardous
situation which, if not avoided, may result in injury. It
may also be used to alert against unsafe practices.
Use Proper Fabrication Methods
Follow all instructions related to Swanstone
fabrication. Failure to follow such instructions
could cause the components to separate after
installation, resulting in personal injury. Failure to follow
these instructions could also result in water damage.
Tripping Hazard
Personal injury can result from tripping over
power cords, tools, or other items. DO NOT
leave items laying around the work area.
Personal Protection
Be sure to use all personal protective
equipment, such as dust mask, safety
eyewear or goggles, and sturdy work
boots, preferably with steel toes, to ensure your own
safety. To prevent possible damage to your hearing,
always wear ear protection, such as earmuffs or
earplugs, when working around power tools.
Cutting Hazard
The installation of the Swan Corporation
product will require using power tools. Keep
hands away from the cutting edge of any tool
used in the installation of our product. Placing fingers in
or around the cutting blades could result in serious
personal injury.
Room Temperature
Allow the components and adhesives
to adjust to room temperature for at
least six hours before installation. The
product should be installed at temperatures not less than
65°F and should not be installed in areas where the
temperature may drop below freezing (32°F). Failure to
follow this recommendation could adversely affect the
adhesives.
CAUTION
IMPORTANT NOTICE
800-325-7008 3 The Swan Corporation
Safety Guidelines