Swanstone ULAD-1913 - Installation - Manual (Page 13)

1 Use 120 grit sanding pads to remove router bit
bearing marks, and to blend edges and seams.
2. Use 220 grit sandpaper to remove sanding
scratches and open up the surface to fully reveal the
Swanstone pattern. Sand the entire surface of the
sink and countertop.
3. Use 320 grit sandpaper or Scotchbrite to achieve a
final finish. Sand the entire surface of the sink and
countertop.
Note: Inspect all joints and seams, looking for gaps or
cracks. If voids in the adhesive joints are found, the
components should be taken apart and reglued.
800-325-7008 13 The Swan Corporation
Finishing