Swanstone SD-DTF-C - Installation - Manual (Page 4)

4
Lift Door Assembly (D) and Panel Assembly (C) onto the base ledge
and slide them onto their respective Wall Jambs (A & B) as shown
above.
STEP 4
Install Door and Panel Assemblies
figure 4
STEP 6
Caulk for a leak proof installation
TO INSURE A LEAK PROOF INSTALLATION:
First: Run a bead of clear mildew resistant caulking around
the outside of shower enclosure where shower unit meets
the shower base and where Wall Jambs meet wall (see
figure 6).
Second: From inside the shower unit, caulk the two(2)
circled areas indicated in figure 6 above (caulk the crevice
where the horizontal member meets the vertical member as
shown in figure 6b).
figure 6
Carefully follow caulking manufacturer's instructions before
using shower.
Unit Installation Screws (shown full size for reference)
STEP 5
Work Corner and Secure Unit
Work the corner of the Door and Panel assemblies to engage their full
length as shown in figure 5. After assemblies are engaged . . . adjust
the unit along the curb as required.
When satisfied, secure the Door and Panel Assemblies to the Wall
Jambs using six(6) #6 x 3/8" self drilling phillips screws (G) three(3)
per side. Secure Assemblies to each other at corner using three(3)
#6 x 3/8" self drilling phillips screws (G).
figure 5
figure 6b