Swanstone WW-6000 - Installation - Manual (Page 24)

The Swan Corporation 24 800-325-7008
4. Install the back panel. Carefully center the
overlapping panel and press firmly to the wall. Keep
the top edge of the panels aligned when installing
the adjacent panels. Use even hand pressure from
top to bottom and side-to-side to ensure solid wall
contact.
Note: Any gaps between the bottom of the panels and
the tub ledge will be filled in with caulking in a later step.
Refer to the Temporary Bracing section for information on
bracing to hold the panels in place until the silicone
adhesive is completely set (usually 24 hours). This will
allow proper curing of the silicone.
5. Install temporary bracing to hold the wall panels in
place until the silicone adhesive cures.
6. After the temporary bracing is removed, refer to the
Caulking section for information on applying color
coordinated caulk to joints and seams.
Window Trim Kit WTK-1
1. Measure width (A) and depth (B) of the window
opening. Cut the sill panel 1-1/2 inches less than
the width of the window opening (cut off the end with
the factory holes, they are not used).
B
A
A – 1½”
IMPORTANT NOTICE
Installation Procedure