Prokit's Industries MT-3109 - Manual (Page 21)

MT-3109 AC/DC Digital Clamp Multimeter
●Change to AC:
Change to AC by using average response method. Input sine
wave, then adjust the reading until it is same as the effective
value.
J. Capacitance
Range Resolution Accuracy Overload
Protection
40nF 10pF
Measure at REL
mode ±(5 %+1 0)
400nF 100pF
4uF 1nF
40uF 10nF
±(5%+1 0)
100uF 100nF ±(6%+10)
600Vp
MAINTENANCE
This section provides basic maintenance information including
battery replacement instruction.
Warning
Do not attempt to repair or service your Meter unless you are
qualified to do so and have the relevant calibration, performance
test, and service information
To avoid electrical shock or damage to the Meter, do not get
water inside the case.
A. General Service

Periodically wipe the case with a damp cloth and mild
detergent. Do not use abrasives or solvents.
 To clean the terminals with cotton bar with detergent, as dirt
or moisture in the terminals can affect readings.
 Turn the Meter power off when it is not in use.
 Take out the battery when it is not using for a long time.
 Do not use or store the Meter in a place of humidity, high
temperature, explosive, inflammable and strong magnetic
field.
20