Prokit's Industries PT-1361 - Manual (Page 6)

5
cordless screwdriver and for preventing the cordless screwdriver from being switched on
inadvertently. You can select between clockwise and counter- clockwise rotation. Change
the direction of rotation only when the equipment is at a standstill. If you fail to observe this
point, the gearing may become damaged. When the slide switch is in the middle position,
the ON/OFF switch is blocked.
6.3 ON/OFF switch (Fig. 2 / Item 9)
Press the On/Off switch to switch the cordless screwdriver on. Release the ON/OFF switch
to switch off the tool.
6.4 LED lamp (Fig. 1/Item 2)
The LED lamp (2) can be used in poor lighting conditions to illuminate the area where you
want to screw. To switch ON, press the switch (4) and to switch OFF press the switch (4)
again.
6.5 Angle setting (Fig. 1,3/Item 3)
The screwdriver can be locked into 2 different angle settings. To do so, press the locking
button (3) and move the screwdriver into the desired position. Then release the locking
button (3).
Important.
Before you switch on the screwdriver, make sure that it is correctly locked in the
angle position in question.
6.6 Battery capacity indicator (Fig. 4/Item 5)
Press the button for the battery capacity indicator (6). The battery capacity indicator (5)
indicates the charge state of the battery on 3 colored LEDs.
All LEDs illuminate:
The battery is fully charged
The yellow and red LED illuminate:
The battery has an adequate remaining charge
Red LED:
The battery is empty, recharge the battery
6.7 Changing the tool (Fig. 5)
Important!
Set the changeover switch to its centre position whenever you carry out any work (for
example changing the tool, maintenance work, etc.) on the cordless screwdriver. Pull back
and hold the locking sleeve (13). Insert the bit (a) into the bit chuck (1) and let go of the
locking sleeve (13). Check that it is secure by attempting to pull the tool apart again.