Prokit's Industries PT-1361 - Manual (Page 5)

4
Only use appliances which are in perfect working order. Service and clean the appliance
regularly. Adapt your working style to suit the appliance. Do not overload the appliance.
Residual risks
Even if you use this electric power tool in accordance with instructions, certain
residual risks cannot be rules out. The following hazards may arise in connection
with the equipment’s construction and layout:
1. Lung damage if no suitable protective dust mask is used.
2. Damage to hearing if no suitable ear protection is used.
3. Health damage caused by hand-arm vibrations if the equipment is used over a
prolonged period or is not properly guided and maintained.
5. Before starting the equipment
Be sure to read the following information before you use your cordless screwdriver for the
first time:
1. Charge the battery pack with the charger supplied.
2. Only ever use screwdriver bits which are suitable for the purpose and in faultless
condition.
3. Always check for concealed electric cables and gas and water pipes when drilling and
screwing in walls.
6. Operation
6.1 Charging the battery (Fig. 1)
The battery is protected from exhaustive discharge. An integrated protective circuit
automatically switches off the equipment when the battery is flat. In this case the bit chuck
will cease to turn.
Warning!
Do not press the ON/OFF switch any more if the protective circuit has actuated. This may
damage the battery.
1. Check that your mains voltage is the same as that marked on the rating plate of the
battery charger. Plug the battery charger in the plug socket and connect the charging
cable to the charging connection. The charging process starts as soon as the charging
cable is connected to the charging adapter.
2. The red LED (7) will come on to indicate that the battery pack is being charged.
3. The charging control lamp (7) goes out when charging is completed.
Important!
The handle may become a little warm during the charging process. This is normal. If the
battery pack fails to charge, please check whether there is voltage at the socket-outlet and
check for proper contact with the charging contacts in the battery charger If the battery still
fails to charge, send the battery charger and the screwdriver to our customer services
department. Timely recharging of the battery pack will help it serve you well for a long time.
You must recharge the battery pack when you notice that the power of the screwdriver
drops.
6.2 Changeover switch (Fig. 2/Item 10)
The slide switch above the ON/OFF switch is for setting the direction of rotation of the