Knape&Vogt 1574 Spacer Spacer kit - Manual (Page 2)

1572-QR
Hmax = Door Height + 2-3/8"
Hmin = Door Height + 1-7/8"
1
PREPARE OPENING
2-Door Width = 2 x Door Width - 1"
SLIDING DOOR HARDWARE - BY PASS
Assembly
Instructions
1572-QR:
1-1/2" - 1-7/8"
(3,8 cm - 4,8 cm)
#310323_A (0912)
3/8" - 1/2"
(1 cm - 1,3 cm)
1
2
MOUNT FRAME HARDWARE
• Center track in opening.
•
IMPORTANT: Place hangers loose
into track before securing.
• Using track as template, mark
screw locations.
• For 1-3/8" door, use 5/16"
diameter spacer. (fig. A)
• For 1-3/4" door, use 3/4"
diameter spacer. (fig. B)
• Drill 3/32" pilot holes and
secure with (#8 x 5/8") screws.
Note: If necessary, track may be cut
with a fine tooth saw.
3
MOUNT DOOR HARDWARE
• Place quick release top mount plates
on top of each door at the distance
shown from the outside edge.
• Using brackets as a template,
drill 3/32" holes and secure
with (#8 x 1") screws.
• Drill 7/8" diameter hole
approximately 1/4" deep
on outside edge of each
door as shown to mount pulls.
2" (5,1 cm)
1-1/2"
(3,8 cm)
36"
(91,4 cm)
Opening Height
Hauteur Ouverture
Altura Abertura
Door Height
Hauteur Porte
Altura Puerta
B A