Knape&Vogt PB-0340 Jump-proof guard - Manual

SLIDING DOOR HARDWARE - Jump-Proof Guard ™
For use with By-Pass Doors
Assembly
Instructions
Drill (3/32") • Perceuse (3/32”) • Taladro (3/32”)
Phillips Screw Driver • Tournevis Phillips • Destornillador Phillips
Tools Required • Outils requis • Herramientas requeridos
CONTENTS QTY
A. Jump-Proof Guard ™ 4
B. #8 x 3/4" Pan Head Screw 8
A.
#310368_A (0413)
Jump-Proof Guards ™ , properly mounted on top back edge of doors alongside
existing carriers, prevent doors from rising or jumping enough to allow wheels
to escape from the track.
1. Position Jump-Proof Guard ™ on top back edge of door next to roller.
2. Locate one screw in each slot of the Jump-Proof Guard ™ approximately
1/4" or less from the top of the slot.
Note: It is recommended to pre-drill (3/32") pilot holes to avoid splitting.
3. Adjust Jump-Proof Guard ™ upward as far as possible without touching
the track. Tighten screw securely. Repeat for each Jump-Proof Guard ™
(two per door). The gap thickness between the guard and the track
should be about 1/16" (1.5 mm) or less.
B.
1.
2.
3.
Hanger-Roller
Jump-Proof Guards ™