Warning, Fi g. 6.1, Fi g. 6.2 – Peerless-AV SS560F - Installation User Manual

Page 7

7 of 9

ISSUED: 08-05-11 SHEET #: 009-9054-4 07-25-12

Attaching Display using VESA 100, 200 or VESA 300 Mounting Pattern

• If screws don't get three complete turns in the display inserts or if screws bottom out and adapter plate is still not

tightly secured, damage may occur to display or product may fail.

WARNING

If you have any questions, please call Peerless customer care at 1-800-865-2112.

Select the screws from the baffl ed fastener pack that best fi t your display.

Begin with the shortest length screw,

hand thread through multi-washer and

adapter plate (D)

into display as shown below. Screw must make at least

three full turns into the mounting hole and fi t snug into place. Do not overtighten. If screw cannot make three full
turns into the display, select a longer length screw from the baffl ed fastener pack. Repeat for remaining mounting
holes and tighten screws.

NOTE: Spacers may not be used, depending upon the type of display.

Select the screws from the baffl ed fastener pack that best fi t your display. Begin with longer length screw, hand
thread through multi-washer, adapter plate (D) and spacer in that order into display as shown below. Screw must
make at least three full turns into the mounting hole and fi t snug into place. Do not overtighten. If screw cannot
make three full turns into the display, select a longer length screw from the baffl ed fastener pack. Repeat for
remaining mounting holes and tighten screws.

For Flat Back Display

For Bump-out or Recessed Back Display

6-1

6-2

DISPLAY

fi g. 6.1

MULTI-WASHER

SCREW

MULTI-WASHER

SCREW

fi g. 6.2

SPACER