Peerless-AV PA740 - Installation - Manual (Page 9)

9 of 46 ISSUED: 01-27-08 SHEET #: 095-9283-8 01-25-12
Attaching Tilt Knob to Wall Mount (optional)
For tool-less tilt adjustment, replace one 1/4-20 x
1/2" screw with tilt knob (D). Drive one 1/4-20 x 1/2"
screw four turns and then remove. Hand thread tilt
knob (D) into wall mount (A) leaving 1/4" exposed
thread as shown in front view.
NOTE: Be sure four 1/4-20 x 1/2" screws have 1/4"
exposed thread.
• Do not lift more weight than you can handle.
Use additional man power or mechanical lifting
equipment to safely handle placement of the display.
WARNING
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 20 in. • lb (2.26 N.M.) maximum torque.
• Be careful not to pinch fi ngers when opening and
closing mount from the wall.
CAUTION
To attach display to wall mount (A), hook tilt bracket
onto four 1/4-20 x 1/2" screws.
Installing and Removing Flat Panel Display
5
1/4-20 X 1/2"
SCREWS
A
Adjust display to desired tilt (15° forward,
5° backward), then tighten four 1/4-20 x 1/2" screws.
Hold display securely to remove from mount. Loosen four
1/4-20 x 1/2" screws and lift display away to disengage tilt
bracket from mount.
1/4-20
X
1/2"
SCREWS
FRONT VIEW
REPLACE LEFT OR RIGHT
1/4-20 x 1/2" SCREW WITH TILT KNOB
A
D
1/4"
1/4"
4