Peerless-AV HLG440-RCA-Q10 - Installation - Manual (Page 3)

ISSUED: 06-29-11 SHEET #: 125-9220-4 07-31-12
Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-729-0307 or 708-865-8870.
3 of 6
PoINt 1 PoINt 2
tABLe toP
Use lock-down plate ( A) as a template to mark location of holes at point 1 and point 2, spaced 7.00" apart on
table. Drill two holes using a 9/32'' drill bit. Carriage bolts ( D) must be placed into slots as shown in fig. 2.1 before
mounting lock-down plate to display.
option 1: Maximum Front to Back Adjustment, 2-1
option 2: Minimum Front to Back Adjustment, 2-2
Fig. 2.1
PoINt 1 PoINt 2
tABLe toP
Use lock-down plate ( A) as a template to mark location of holes at point 1 and point 2, spaced 6.03" apart on
table. Drill two holes using a 9/32'' drill bit. Carriage bolts ( D) must be placed into slots as shown in fig 2.3 before
mounting lock-down plate to display.
Fig. 2.3
Fig. 2.4
7.00"
(178 mm)
6.03"
(153 mm)
SLotS
A
D
SLotS
A
D
Fig. 2.2
2
2-1
2-2
Place lock-down plate ( A) onto bottom of display base. Use as a template to mark location of six mounting holes.
Drill two pilot holes using a 1/8'' drill bit into bottom of display base as shown in fig 1.1.
Note: Do not drill though display base.
Four 10-32 X 3/8" undercut
flathead screw ( B)
Two #10 X 3/8" undercut
flathead self drilling screw ( C)
Fig. 1.1
RCAJ32L750
(Mounting to RCAJ42L750 Skip to Page 4)
1
Drill two holes using a 1/8'' drill bit
into bottom of display base.