Peerless-AV DS-VW765-POR - Installation - Manual (Page 10)

10 of 12 ISSUED: 05-13-11 SHEET #: 145-9012-8 2013-06-25
8
Open adapter brackets ( B) by pulling down on the long cords while pulling bottom of display away from wall.
NOTE: Kick stand will automatically engage. Make sure kick stand is in down postion before resting the display.
NOTE: Extended position is for service access only. The mount must be closed during normal use and operation.
NOTE: Display not shown for clarity.
OPEN Adapter Brackets: LONG CORDS
TO OPEN, PULL DOWN LONG CORDS
KICK STAND IN
DOWN POSITION
B
SHORT CORDS
KICK STAND
B
LONG CORDS
CLOSE Adapter Brackets: SHORT CORDS
Slightly pull display away from wall to release kick stand while pulling down on short cords.
NOTE: Once short cords are pulled, kick stand will disengage.
NOTE: Support the display until the adapter brackets (B) are engaged in the closed position.
TO CLOSE,
PULL DOWN SHORT CORDS