Peerless-AV MIS488 - Installation - Manual (Page 4)

4 of 4 ISSUED: 11-19-07 SHEET #: 124-9135-2 01-06-11
NOTE: Use safety belt (Z) instruction in conjuction with this step.
Fasten clear strips to the two slots in PC bracket (Q). Set HD box into computer plate (B). Fasten belt with
cinch buckle to belt without cinch buckle. Place tri-bar belt clips and belt guide onto belt as shown in the safety
belt instructions. Feed the ends of the belt through the PC bracket (Q) slots and through tri-bar belt clip. Cinch
the end of the belt so that the PC is securely held.
NOTE: Trim off the end of the belt if necessary, then lightly burn the end of the belt to prevent fraying.
© 2011, Peerless Industries, Inc. All rights reserved.
All other brand and product names are trademarks or registered trademarks of their respective owners.
4
BELT WITH
CINCH BUCKLE
BELT WITHOUT
CINCH BUCKLE
TRI-BAR BELT CLIP
BELT GUIDE
PC
CLEAR STRIPS
Q
PC
BELT WITH
CINCH BUCKLE
BELT WITHOUT
CINCH BUCKLE