Peerless-AV SUA751H - Installation - Manual (Page 8)

8 of 9 ISSUED: 05-03-12 SHEET #: 125-9296-1
• Tighten screws so display brackets are firmly attached to display. Do not tighten with excessive force.
Overtightening can cause stress damage to screws, greatly reducing their holding power and possibly causing
screw heads to become detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
• If screws don't get three complete turns in the display inserts or if screws bottom out and bracket is still not tightly
secured, damage may occur to display or product may fail.
WARNING
Installing Adapter Brackets to Display
2 FIGURE 2.1
DISPLAY
ADAPTeR
PLATe
keYHOLe SLOT
ADAPTER PLATE MoUNTING DETAIL
1/8"
DISPLAY
Use adapter plate detail figure 2.1 to determine
display hole pattern.
To prevent scratching the display, set a cloth on a flat,
level surface that will support the weight of the display.
Place display face side down. Fasten two
M8 x 10 mm socket pin screws ( K) or M8 x 15 mm
socket pin screws ( L) or M6 x 12 mm socket pin
screws ( E) into top mounting holes in back of display
as shown in figure 2.2
Hook exposed screws into keyhole slots on adapter
plate on wall arm assembly (A) and secure using two
M8 x 10 mm socket pin screws ( K) or M8 x 15 mm
socket pin screws ( L) or M6 x 12 mm socket pin
screws ( E) into bottom mounting holes
as shown in figure 2.3.
FIGURE 2.2 FIGURE 2.3
E, K, or L
E, K, or L
15.75"
(400 mm)
11.81"
(300 mm)
15.75"
(400 mm)
11.81"
(300 mm)