Peerless-AV FPZ-600 - Installation - Manual (Page 4)

4 of 7 ISSUED: 02-14-06 SHEET #: 202-9099-2 06-16-06
Slide two main tubes (C) onto base (A) and secure
using four set screws (E) as shown in figure 2 and
detail 1. Tighten screws using 4 mm allen wrench (O).
1
Slide carriage (B) onto main tubes (C). Slide carriage to desired height and secure using four set screws (E) as
shown in figure 3 and detail 2. Tighten screws using 4 mm allen wrench (O).
Note: Orientation of "UP" arrow is critical.
2
C
A
DETAIL 1
fig 2
C
fig 3
For some situations, bumper strip (P) may be
required to keep base (A) level. If so, cut bumper
strip (P) into five equal pieces and adhere one piece
to each corner and one piece to center of bottom
side of base (A).
Note: The pieces can also be used in other locations
on the base's bottom for other situations.
P
A
3
DETAIL 2
E
E
B