Peerless-AV LCH-100 - Installation - Manual (Page 4)

ISSUED: 09-30-02 SHEET #: 090-9085-6 07-23-13 4 of 5
Place nylon washer (L) and pivot head (B) on top pin
of telescopic pedestal (A) as shown. To restrict rotation
of LCD screen to 90°, lineup rear set screw with slot
and tighten where shown in detail 3 using 3 mm allen
wrench (N). To completely restrict rotation, tighten rear
set screw using 3 mm allen wrench (N).
SET SCREWS
B
A
L
SLOT
REAR SET
SCREW
DETAIL 3
Turn tube nut counterclockwise to loosen. Gently hold pivot head
(B) down with one hand, and gently press on lock ball with the other
hand. Lock ball must be inserted into outer tube to obtain up and down
movement. Do not insert lock ball all the way into the inner tube.
Adjust to desired height making sure to locate lock ball into one the
four holes as shown.
NOTE: Setting the lock ball in the lowermost hole requires the removal
of the inner white plastic ring. To do this set the lock back in a
different hole. Slowly unscrew the tube nut until it comes off threads.
Remove the white plastic ring inside the tube nut. Retighten the tube
nut. Adjust the height until the lock ball reaches the lowermost hole.
TUBE NUT
LOCK BALL
A
BACK VIEW
B
INNER TUBE
OUTER TUBE