Peerless-AV SR560G - Installation - Manual (Page 11)

11 of 13 ISSUED: 01-10-07 SHEET #: 009-9033-13 05-23-12
NOTE: "X" dimensions should be equal.
• Tighten screws so adapter brackets are fi rmly attached. Do not tighten with excessive force. Overtightening can
cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become
detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
• If screws don't get three complete turns in the screen inserts or if screws bottom out and bracket is still not tightly
secured, damage may occur to screen or product may fail.
WARNING
Installing Adapter Brackets
G
CENTER BRACKETS
VERTICALLY ON
BACK OF SCREEN
X
X
MEDIUM HOLE FOR M5 SCREWS
SMALL HOLE FOR M4 SCREWS
LARGE HOLE FOR M6 SCREWS
Notes:
• The number of fasteners used will vary,
depending upon the type of screen.
• Multi-washers and spacers may not be
used, depending upon the type of screen.
• Use the corresponding hole in the multi-
washer that matches your screw size as
shown.
MULTI-WASHER
NOTE: For Dedicated Adapter Plate, see step 11.
To prevent scratching the screen, set a cloth on a fl at, level surface that will support the weight of the screen.
Place screen face side down. Refer to screen manufacturers instructions or customer service, for removing any
knobs, base, cover, or screw(s) on the back of the screen to prepare mounting. These need to be removed to
allow the adapter brackets to be attached. Select the small, medium, large or extra large screws from the baffl ed
fastener pack then attach adapter brackets to screen following fi gure 14.1 or 14.2.
NOTE: Top and bottom mounting holes must be used for attaching brackets. Verify that all holes are properly
aligned, and then tighten screws using a security allen wrench.
NOTE: For fl at back screens proceed to step 14-1. For bump-out or recessed back screen skip to step 14-2.
14