Warning, Da d, Gc or e f – Peerless-AV HL4UN-002-Q10 - Installation User Manual

Page 2: Figure 3.1 figure 3.2

2 of 2

ISSUED: 06-03-11 SHEET #:120-9110-1

Hand tighten slope nut (

D) through 1/4-20 x 1-3/4" carriage bolt (A) until snug against bottom of desktop surface.

Thread another slope nut (

D) upside-down, about two turns from first slope nut (D). Insert an open box wrench

between both slope nuts (

D) and tighten. NOTE: Avoid jamming both slope nuts (D) together, doing so may make

it difficult to remove slope nut used for tightening first slope nut (

D) as shown in figure 3.1. After slope nut is secure

remove bottom slope nut as shown in figure 3.2. Repeat with remaining 1/4-20 x 1 3/4" carriage bolt (

A).

Fasten two plastic caps (

G).

TIGHTENING

SLOPE NUT

BOTTOM OF DESKTOP

FIGURE 3.1

FIGURE 3.2

NOTE: Do not overtighten slope nut (D)

plate may distort

FRONT

Thread two M4 x 16 phillips pan trilobe screws (

B) to bottom display attachment holes as shown in fig. 4.1.

Remove the two M4 x 16 phillips pan trilobe screws (

B) and attach display screen to display base using two M4 x

16 mm socket pin screws (

I) or M4 x 12 mm socket pin screws (E) with #8 flat washers (F), as shown in figure 4.2.

Tighten with 4 mm security allen wrench (

H). Use TV supplied screws for remaining holes

fig 4.1

fig 4.2

DISPLAY SCREEN

DISPLAY BASE

NOTE: Display and base may appear

different than illustrated

NOTE: Screws are installed using bottom

two display mounting locations.

Installation of Security Screws for Base/Screen Assembly

C or E

• If screws don’t get three complete turns in the screen inserts or if screws bottom out and bracket is still not tightly

secured, damage may occur to screen or product may fail.

WARNING

All other brand and product names are trademarks or registered trademarks of their respective owners.