Peerless-AV HL4UN-002-Q10 - Installation - Manual

1 of 2 ISSUED: 06-03-11 SHEET #:120-9110-1
Insert two 1/4-20 x 1-3/4" carriage bolts ( A)
into bottom of display base as shown in detail 1.
Model: HL4UN-002, HL4UN-002-Q10
Installation and Assembly:
Lock Down Hardware for Display Base Stands
1
BOTTOM OF BASE
FRONT
2
FRONT
A B
C
D
A
DETAIL 1
MEASURE
DISTANCE
Measure distance between center lines of cut outs in
bottom of display base. Use measurement to mark
location of holes at point 1 and point 2, on table.
Drill two holes using a 9/32'' drill bit.
POINT 1
POINT 2
• drill
• 9/32" drill bit
• 5/8" open box wrench
E F
G
H
TOOLS NEEDED
HL4UN-002 HL4UN-002-Q10
Description Qty. Part # Qty. Part #
A 1/4-20 x 1 3/4" carriage bolt 2 520-1017 20 520-1017
B M4 x 16 mm phillips trilobe screw 2 520-2621 20 520-2621
C M4 x 16 mm socket pin screw 2 520-1087 20 520-1087
D 1/4-20 sloped nut 3 530-0035 23 530-0035
E M4 x 12 mm socket pin screw 2 520-1079 20 520-1079
F #8 flat washer 2 540-1001 20 540-1001
G plastic cap 2 590-1294 20 590-1294
H 4 mm allen wrench 1 560-9646 3 560-9646
Parts List
NOTE: Display and base may appear
different than illustrated