Peerless-AV HF646-C63 - Installation - Manual (Page 5)

5 of 7 ISSUED: 10-22-09 SHEET #: 125-9085-2 11-18-09
Rotate toggler (D)
clockwise to wedge it
against inside walls
of metal stud.
Push into hole.
Pivot end of toggler (D).
Slide plastic cap
forward while pulling
back firmly on ring.
Break off excess.
FOR METAL STUD WALLS ONLY: Drill three 1/2" (13 mm) dia.
holes through drywall and studs at locations corresponding to
wall bracket (A). Insert togglers (D) as shown below.
D
Align wall bracket (A)
with hole in wall and
fasten using
1/4-20 x 2.5" screw (F).
F
• Product must be mounted through drywall that has a
minimum thickness of 1/2" and into metal studs, 26
gauge or heavier.
• Make sure that togglers are anchored into the center
of the studs as shown in figure 1.3. The use of an
"edge to edge" stud finder is highly recommended.
fig. 1.3
WARNING
A
D
F
Secure using three 1/4-20 x 2.5 phillips screws (F).
A