Peerless-AV HF646-C63 - Installation - Manual (Page 3)

3 of 7 ISSUED: 10-22-09 SHEET #: 125-9085-2 11-18-09
Installation to Single Wood Stud Wall
1 Use a stud finder to locate the edges of the stud. Use of an edge-to-edge stud finder is highly recommended. Based
on its edges, draw a vertical line down the stud’s center. Place wall bracket (A) on wall as a template, making sure
that the three mounting holes are over the stud centerline. Level plate, and mark the center of the three holes. Drill
three 5/32" (4 mm) dia. holes 2-1/2" (64 mm) deep. Make sure that the wall plate is level, secure it using three
#14 x 2.5" wood screws (G) as shown in figure 1.2.
Skip to step 2 on page 5.
• Installer must verify that the supporting surface will safely support the combined weight of all attached equipment and
hardware.
• Tighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the
screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud finder is
highly recommended.
• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Installers
are responsible to provide hardware for other types of mounting situations.
WARNING
G
A
STUD