Peerless-AV ESA746PU - Installation - Manual (Page 9)

9 of 35 ISSUED: 01-15-11 SHEET #: 061-9061-3 11-19-13
C
fi g 3.1
A
TENSION KNOB
ROLL
BRACKET
fi g. 4.1
fi g. 4.2
K
SAFETY
SCREWS
C
A
CROSS
SECTION
Mounting and Removing Flat Panel Screen
Hook adapter brackets (C) onto center of adapter
plate (A). NOTE: Adapter brackets (C) must be
centered on adapter plate (A) or product may not
function properly. Turn security screws, using a
phillips screwdriver, clockwise at least six times to
prevent screen from being removed as shown in
cross section of fi g. 3.1.
NOTE: To lock the screen down, tighten security
screws to wall plate as shown in cross section.
To remove screen from mount, loosen security
screws, swing screen away from mount, and lift
screen off of mount.
3
• Always use an assistant or mechanical lifting equipment to safely lift and position the fl at panel screens.
WARNING
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.
CAUTION
Hold screen securely and loosen tension knob on
side of mount shown in fi gure 4.1 to allow for tilt.
Adjust screen to desired tilt (15° forward, 5°
backward), then retighten tension knob.
Rotate screen by hand to level screen. Roll bracket
allows 2° roll adjustment.
Insert #10-32 x 1/4" fl at head phillips screw (K) to
lock screen into position as shown in fi gure 4.2.
4
• Be careful not to pinch fi ngers when opening and
closing mount from the wall.
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.
CAUTION
4-1