Peerless-AV SS560G - Installation - Manual (Page 11)

11 of 41 ISSUED: 02-25-11 SHEET #: 009-9051-3 05-16-12
NOTE: "X" dimensions should be equal.
• Tighten screws so adapter brackets are fi rmly attached. Do not tighten with excessive force. Overtightening can
cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become
detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
• If screws don't get three complete turns in the display inserts or if screws bottom out and bracket is still not tightly
secured, damage may occur to display or product may fail.
WARNING
Installing Adapter Brackets
G
CENTER BRACKETS
VERTICALLY ON
BACK OF DISPLAY
X
X
MEDIUM HOLE FOR M5 SCREWS
SMALL HOLE FOR M4 SCREWS
LARGE HOLE FOR M6 SCREWS
Notes:
• The number of fasteners used will vary,
depending upon the type of display.
• Multi-washers and spacers may not be
used, depending upon the type of display.
• Use the corresponding hole in the multi-
washer that matches your screw size as
shown.
MULTI-WASHER
To prevent scratching the display, set a cloth on a fl at, level surface that will support the weight of the display.
Place display face side down. Refer to display manufacturers instructions or customer service, for removing any
knobs, base, cover, or screw(s) on the back of the display to prepare mounting. These need to be removed to
allow the adapter brackets (G) to be attached. Select the small, medium, large or extra large screws from the
baffl ed fastener pack then attach adapter brackets to display following fi gure 14.1 or 14.2.
NOTE: Top and bottom mounting holes must be used for attaching brackets. Verify that all holes are properly
aligned, and then tighten screws using 4 mm security allen wrench (Q).
NOTE: For fl at back displays proceed to step 14-1. For bump-out or recessed back display skip to step 14-2.
14