Peerless-AV PLAV70-UNLP-GB - Installation - Manual (Page 13)

13 of 14 ISSUED: 11-21-06 SHEET #: 202-9180-7 06-14-12
Position of screen may be adjusted vertically up to .79" in each direction by doing the following:
• To raise screen, turn hex nut shown in fi gure 10.1 clockwise with 3/4" open-end wrench (not provided).
• To lower screen, turn hex nut shown in fi gure 10.1 counterclockwise with 3/4" open-end wrench (not provided).
If it is too diffi cult to adjust roll of plasma, loosen
screws shown in fi gure 9.1 using a phillips
screwdriver.
IMPORTANT! Do not loosen or tighten screws
more than 1/8 turn. Depending on the specifi c size & weight of the plas-
ma, articulating swing arm may be angled at different
positions, causing plasma to appear to lean sideways
at different articulating positions. Tilt-roll assembly (B)
allows plasma to be manually adjusted, so plasma
can be horizontal at all positions. To adjust, gently
rotate plasma by hand to desired position. 9
9-1
ARTICULATING
ARM
PLASMA
10
fi g 9.1
HEX
NUT
fi g 10.1
© 2011, Peerless Industries, Inc. All rights reserved.
All other brand and product names are trademarks or registered trademarks of their respective owners.
ROLL
ADJUSTMENT
SCREWS