Fi g 7.1, Fi g 10.1 – Peerless-AV PLAV70 - Installation User Manual

Page 9

9 of 10

ISSUED: 05-02-06 SHEET #:202-9089-4 06-29-11

7-1

Depending on the specifi c size & weight of the plas-
ma, articulating swing arm may be angled at different
positions, causing plasma to appear to lean sideways
at different articulating positions. Tilt roll assembly (B)
allows plasma to be manually adjusted, so plasma
can be horizontal at all positions. To adjust, gently
rotate plasma by hand to desired position.

Position of screen may be adjusted vertically up to .79"
in each direction by doing the following:
• To raise screen, turn hex nut shown in fi gure 8.1
clockwise with 3/4" open-end wrench (not provided).
• To lower screen, turn hex nut shown in fi gure

8.1 counterclockwise with 3/4" open-end wrench (not
provided).

If it is too diffi cult to adjust roll of plasma, loosen
screws shown in fi gure 7.1 using a phillips screw-
driver.

IMPORTANT! Do not loosen or tighten screws
more than 1/8 turn.

ARTICULATING

ARM

PLASMA

fi g 7.1

ROLL

ADJUSTMENT

SCREWS

HEX
NUT

fi g 10.1

All other brand and product names are trademarks or registered trademarks of their respective owners.