Peerless-AV FPZ-670 - Installation - Manual (Page 4)

4 of 7 ISSUED: 05-08-08 SHEET #: 202-9280-1
Slide two main tubes (A) onto base (B) and secure
using four set screws (Q) as shown in figure 2 and
detail 1. Tighten screws using 4 mm allen wrench (S). 1 2
fig 2
For some situations, bumper strip (P) may be
required to keep base (B) level. If so, cut bumper
strip (P) into five equal pieces and adhere one piece
to each corner and one piece to center of bottom
side of base (B).
Note: The pieces can also be used in other locations
on the base's bottom for other situations.
P
B
4 3
A
B
E
E
G
T
Slide base cover (E) down tubes (A) onto base (B) as
shown below. Secure using two M5 x 8 mm socket
pin screws (G). Tighten screws using 4 mm allen
wrench (S).
Note: Make sure that notches on bottom of base
cover fit into holes in base.
Slide cable access cover (F) into base cover (E) as
shown below. Secure using socket pin serrated
washer head screw (T). Tighten screws using 4mm
allen wrench (S).
A
B
DETAIL 1
Q