Peerless-AV PRS-UNV - Installation - Manual (Page 10)

ISSUED: 09-19-05 SHEET #: 055-9441-10 06-04-11
Visit the Peerless Web Site at www.peerlessmounts.com
10 of 12
For customer care call 1-800-865-2112 or 708-865-8870.
To adjust yaw (swivel) for threaded rod mounting applications: Loosen locknuts on threaded rods (refer to
step four), until projector mount can be rotated. Rotate mount to desired position and retighten screws or lock-
nuts.
To adjust yaw (swivel) for extension column applications: Loosen screw on projector mount assembly (A)
indicated below until projector mount can be rotated. Rotate mount to desired position and retighten screw.
To adjust pitch (forward and backward tilt): Using 4 mm security t-wrench (L) (security adjustment models)
or a phillips screwdriver (non-security adjustment models), loosen two screws for pitch adjustment on projector
mount assembly (A) indicated below. Tilt mount to desired position and retighten screws.
To adjust roll (side to side tilt): Using 4 mm security t-wrench (L) (security adjustment models) or a phillips
screwdriver (non-security adjustment models), loosen two screws for roll adjustment on projector mount assembly
(A) indicated below. Tilt mount to desired position and retighten screws.
Projector Alignment
A
9
SCREWS FOR PITCH
ADJUSTMENT
SCREW FOR SWIVEL STOP
SCREWS FOR ROLL
ADJUSTMENT
© 2011, Peerless Industries, Inc. All rights reserved.
All other brand and product names are trademarks or registered trademarks of their respective owners.