Warning, Bb & cc bb & cc aa, Fi g 3.1 – Peerless-AV ST635P - Installation User Manual

Page 7

7 of 30

ISSUED: 02-18-08 SHEET #: 202-9249-6 04-05-11

For preset tilt angles use Increlok

™ and for custom

tilt angle use ratchet handle.

INCRELOK

™

: The display can be locked into a

pre-set tilt position of -5

, 0

, 5

, 10

or 15

. Use

locator hole to fi nd tilt position hole and tilt display
to align holes. Tighten IncreLok™ tilt locking
screws on both adapter brackets to lock tilt as
shown in detail 2.

Ratchet Handle:

Loosen ratchet handle (refer to

step 3 for tension adjustment of handle).

Push or

pull from top or bottom of display to adjust tilt as
shown in fi gure 4.1. The tilt can be adjusted to a
maximum of 15° forward or 5° backward.

Tension Adjustment of Ratchet Handle:

Adjust

tension in adapter brackets (BB & CC) by rotating
ratchet handle. NOTE: If obstruction prevents ratchet
handle from rotating, pull handle out while turning will
allow handle to reposition without tightening. Release
and turn handle to tighten or loosen.

Mounting Display: Ratchet handle must be in the
up or down position or interference will occur while
hooking adapter brackets to wall plate (AA). Slowly
hook adapter brackets (BB & CC) onto wall plate (AA)
and swing display down as shown in fi g. 3.1. Adapter
bracket hooks must fully engage wall plate as shown in
detail 1. Using phillips screw driver or security
driver (FF), turn safety/security screws on adapter
brackets (BB & CC) clockwise till screw tip securely
contacts wall plate as shown in cross section.

Display Adjustment: Display can be adjusted
horizontally by loosening safety/security screws on
adapter brackets (BB & CC) three full turns. Adjust
display as shown in fi gure 3.2. Tighten safety/security
screws on adapter brackets till screw tip securely
contacts wall plate as shown in cross section.

Removing Display: To remove display from mount,
loosen safety screws, swing display away from mount,
and lift display off of mount.

Mounting and Removing Flat Panel Display

DETAIL 2

fi g 4.1

IncreLok™

TILT LOCKING

SCREW

LOCATOR

HOLE

RATCHET

HANDLE

TILT

POSITION

HOLES

fi g 3.2

Adjusting the Tilt Angle of the Flat Panel
Display

• Always use an assistant or mechanical lifting equip-

ment to safely lift and position the fl at panel display.

• Do not tighten screws with excessive force.

Overtightening can cause damage to mount. Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.

• Be careful not to pinch fi ngers when pushing display

from the bottom.

WARNING

CROSS SECTION

DETAIL 1

fi g 3.1

RATCHET

HANDLE

SAFETY/

SECURITY

SCREW

All other brand and product names are trademarks or registered trademarks of their respective owners.

Peerless Industries, Inc.

2300 White Oak Circle

Aurora, Il 60502