Peerless-AV PRG-UNV-S - Installation - Manual (Page 12)

12 of 51 ISSUED: 09-30-09 SHEET #: 056-9024-1
Cable Management
To make an opening to route cables through
projector mount assembly, adjust projector
mount assembly to full upward tilt position
by turning knob for tilt adjustment as shown
in fi gure 9.2. Left or right roll position can be
adjusted if more space is required.
NOTE: Be certain tamper resistant
screws are not engaged before making
adjustments (see step 11).
Route cables through top of extension
column as shown in fi gure 9.1 and fi gure
9.2.
NOTE: A method for assisting cables
through extension column may be required
(example: string tied to connector to help
pull through extension column).
Route cables through projector mount
assembly as shown in fi gure 9.2 and
connect to projector.
9
DO NOT CRIMP
WIRES
BEND WIRES OF RCA
PLUGS IN OPPOSITE
DIRECTION
NOTE: INNER
DIAMETER OF
EXTENSION COLUMN
MAY NOT ALLOW
PASSAGE FOR ALL
CONNECTOR TYPES.
ROUTE
CONNECTOR
THROUGH
FIRST
CABLES WITH
COMBINATION OF VGA
CONNECTOR
AND RCA PLUGS
INNER DIAMETER
OF EXTENSION
COLUMN
CABLE
CONNECTOR
EXTENSION
COLUMN
KNOB FOR TILT
ADJUSTMENT
KNOB FOR ROLL
ADJUSTMENT
fi g. 9.2
fi g. 9.1
OPENING FOR
ROUTING CABLES