Peerless-AV HLG442-SB2848-SH-Q10 - Installation - Manual (Page 3)

3 of 4 ISSUED: 09-08-10 SHEET #:125-9142-4 09-15-11
Hand tighten slope nut ( D) through 1/4-20 x 1 3/4" elevator bolt (C) until snug against bottom of desktop surface.
Thread another slope nut ( D) upside-down, about two turns from first slope nut (D). Insert an open box wrench
between both slope nuts ( D) and tighten. NOTE: Avoid jamming both slope nuts (D) together, doing so may make
it difficult to remove slope nut used for tightening first slope nut ( D) as shown in fig 4.1. After slope nut is secure
remove bottom slope nut and add plastic cap ( E) as shown in figure 4.2. Repeat with remaining
1/4-20 x 1 3/4" elevator bolt ( C).
Detail 1
TIGHTENING
SLOPE NUT
3
B
32" Display Base Attachment Location
(note orientation of plate to base)
BOTTOM OF DESKTOP
FIG 4.1 FIG 4.2
C
D
C
4
E
Secure swivel plate assembly ( A) to bottom of display base using four flat head screws (B) in
32" or 42" orientation.
NOTE: Make sure that screws in display base align with slots and holes in swivel plate assembly (A)
as shown below.
FRONT
FRONT
NOTE: Do not overtighten slope nut (D)
plate may distort
42" Display Base Attachment Location
(note orientation of plate to base)
A
BOTTOM OF DISPLAY BASE
DISPLAY
BASE SCREWS