Peerless-AV FPZ-640 - Installation - Manual (Page 4)

4 of 18 ISSUED: 03-29-10 SHEET #: 009-9042-2 07-21-10
Select security screw that best fi ts your screen. Center adapter plate of column (A) on the back of the screen and
align the four mounting holes. Attach column (A) to screen with four screws and four washers using allen wrench
(C) as shown in fi gure 5.1. If screen has a bumped out or recessed back, spacers may be used between the screen
and adapter plate of column (A) as shown in fi gure 5.2. Screw must make at least three full turns into mounting
hole and fi t snug into place.
4
Remove Adapter Plate from Adjustable Column
Remove screw and washer from top of adjustable column (A) using a 1/2" socket wrench as shown in fi gure 4.1.
Remove hex nut and bolt from back of adapter plate. Slide adapter plate of adjustable column (A) off as shown in
fi gure 4.2.
A
5
Mounting and Removing Flat Panel Screen
screw
washer
screen
Figure 5.1 Figure 5.2
spacer
screw
washer
screen
adapter plate
Figure 4.1 Figure 4.2
adapter plate
adapter plate