Warning, Gh f – Peerless-AV LCW620A - Installation User Manual

Page 6

6 of 10

ISSUED: 07-25-11 SHEET #: 090-9204-5 11-30-12

Attaching Adapter Plate to Screen

OPTIONAL: To disassemble adapter plate from arm assembly (B), remove knob attached to bottom of adapter
plate as shown in fi gure 2.1.

To prevent scratching the screen, set a cloth on a fl at, level surface that will support the weight of the screen.
Place screen face side down. If screen has knobs on the back, remove them to allow the adapter plate to be
attached. Place adapter plate on back of screen.

Choose hole pattern as shown in detail 1.

FOR DISPLAYS WITH FLAT BACKS: Attach adapter plate to display using four knobs or remove four knobs and
secure with 12mm screws (F) as shown in fi gure 2.2.

FOR DISPLAYS WITH RECESSED BACKS: Remove knobs from adapter plate and attach to display using four
25mm screws (G) and four spacers (H) as shown in fi gure 2.3.

• Tighten screws so adapter plate is fi rmly attached. Do not tighten with excessive force. Overtightening can cause

stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become
detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.

• If screws don't get three complete turns into the screen inserts or if screws bottom out and arm is still not tightly

secured, damage may occur to screen or product may fail.

WARNING

VESA 100mm

VESA 75mm

VESA 100mm

DETAIL 1

fi g. 2.2

fi g. 2.1

fi g. 2.3

or KNOBS

ADAPTER PLATE

KNOB

2-1