Fi g 8.1, Fi g. 7.1 – Peerless-AV PLAV60 - Installation User Manual

Page 9

9 of 10

ISSUED: 05-02-06 SHEET #: 202-9112-4 06-29-11

FOR PLAV 60 ONLY:

7-1

Depending on the specifi c size & weight of the plas-
ma, articulating swing arm may be angled at different
positions, causing plasma to appear to lean sideways
at different articulating positions. Tilt-roll assembly (B)
allows plasma to be manually adjusted, so plasma
can be horizontal at all positions. To adjust, gently
rotate plasma by hand to desired position.

SOCKET

SCREW

Position of screen may be adjusted vertically up to
.79" in each direction by doing the following:
• To lower screen, turn socket screw shown in fi gure
8.1 clockwise with 10 mm allen wrench (V).
• To raise screen, turn socket screw shown in fi gure
8.1 counterclockwise with 10 mm allen wrench (V).

fi g 8.1

If it is too diffi cult to adjust roll of plasma, loosen
screws shown in fi gure 7.1 using a phillips screw-
driver.

IMPORTANT! Do not loosen or tighten screws
more than 1/8 turn.

ARTICULATING

ARM

PLASMA

fi g. 7.1

ROLL

ADJUSTMENT

SCREWS

All other brand and product names are trademarks or registered trademarks of their respective owners.