Peerless-AV HT642 - Installation User Manual
Page 2
2 of 9
ISSUED: 08-18-08 SHEET #: 125-9012-4 12-19-13
Note:
Read entire instruction sheet before you start installation and assembly.
Tools Needed for Assembly
•
stud finder ("edge to edge" stud finder is recommended)
•
phillips screwdriver
•
drill with 5/16" and 5/32" drill bits
•
5/16" socket wrench
Table of Contents
Parts List .............................................................................................................................................................................. 3
Attaching Adapter Bracket to Screen.................................................................................................................................... 4
Installation to Wood Stud Wall ............................................................................................................................................. 5
Installation to Solid Concrete and Cinder Block Wall ............................................................................................................ 6
Installation to Metal Stud ...................................................................................................................................................... 7
Attaching Mounting Bracket Using Hook On Option ............................................................................................................. 8
Attaching Mounting Bracket Using Tilt Option ...................................................................................................................... 9
For customer care call (800) 729-0307 or (708) 865-8870.
• Do not begin to install your Peerless product until you have read and understood the instructions and warnings
contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please
call Peerless customer service at 1-800-729-0307.
• This product should only be installed by a qualified professional.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached hard-
ware and components.
• Never exceed the Maximum Load Capacity of 100 lb (45.4 kg).
• If mounting to wood wall studs, make sure that mounting screws are anchored into the center of the studs. Use of an
"edge to edge" stud finder is highly recommended.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding
power.
• This product was designed and intended to be mounted to the following supporting surfaces checked below with the
hardware included in this product as specified in the installation sheet. To mount this product to an alternative support-
ing surface, contact Peerless customer care at 1-800-865-2112.
• This product was designed to be installed on the following wall construction only;
WALL CONSTRUCTION
ADDITIONAL HARDWARE REQUIRED
x
Wood Stud
None
x
Wood Beam
None
x
Solid Concrete
None
x
Cinder Block
None
x
Metal Stud
None
Brick
Contact Customer Service
Other or unsure?
Contact Customer Service
WARNING