Peerless-AV SLAMU - Installation - Manual (Page 5)

5 of 24 ISSUED: 11-30-09 SHEET #: 095-9313-5 10-25-11
Align brackets (B) vertically on back of screen. Select screw (E, F, G, H, M or N) that best fi ts your
screen. Attach brackets (B) to screen with four selected screws and four washers (I) at the top and
bottom of each bracket using allen wrench (L) as shown in detail 1. Spacers (J) may be used to add
additional space between the screen and brackets (B) if screen manufacturer requires more than
1.1" (2.8 mm) of ventilation, or if the screen has a bump-out or recessed back as shown in detail
2. Screw must make at least three full turns into the mounting hole and fi t snug into place. Tighten
screws fi rmly. Do not overtighten.
2
Installing Brackets
Detail 1
I
SCREW
I
SCREW
Detail 2
J
B B
NOTE: Latch
indicates bottom
of brackets (B)