Peerless-AV SLAMU - Installation - Manual (Page 3)

3 of 24 ISSUED: 11-30-09 SHEET #: 095-9313-5 10-25-11
Installation to Wood Stud Wall
1
Use wall mount (A) as a template, make sure it is level, and mark two mounting holes along the
center line of the wood stud. Measure 4.8" (122 mm) left or right from stud's center to determine
center of screen mounting plate. Drill two 5/32" (4 mm) dia. holes 2.5" (64 mm) deep. Level wall
mount (A) and attach to wall with two wood screws (C) into stud center. Use of an edge to edge stud
fi nder is highly recommended. Tighten screws fi rmly, but do not overtighten. Insert two fastener caps
(P) into wall plate mounting holes. NOTE: Be sure arrow of label is facing up when mounting wall arm
assembly (A) to wall as shown.
For cable management option, install cable anchor (T) to bottom mounting hole with wood screw (C).
Do not over tighten screws, or damage may occur.
WARNING
C
A
TOP CUTAWAY VIEW
Wood screws must
center in stud
STUD
WARNING
C
P
A
T