Peerless-AV HT642-002 - Installation - Manual (Page 5)

5 of 9 ISSUED: 03-02-11 SHEET #: 125-9192-1
Installation to Metal Stud Walls
Rotate toggler ( G)
clockwise to wedge it
against inside walls
of metal stud.
Push into hole.
Pivot end of
toggler ( G).
Slide plastic cap
forward while pulling
back firmly on ring.
Break off excess.
FOR METAL STUD WALLS ONLY: Drill four 1/2"
(13mm) dia. holes through drywall and studs at lo-
cations corresponding to wall plate. Insert togglers
( G) as shown below...
Skip to Step 2 page 7
G
Align wall plate with
hole in wall and
fasten using 1/4-20 x
2.5" screw ( H).
wall plate H
• Product must be mounted through drywall that has a
minimum thickness of 1/2" and into metal studs, 26
gauge or heavier.
• Make sure that togglers are anchored into the center
of the studs as shown in figure 1. The use of an
"edge to edge" stud finder is highly recommended.
WARNING
H
B
G
STUD
1-1
1-2
1-3
1-4
1-5
1
3-6
Skip to Step 5
fig. 1