Peerless-AV PRG-JVC-DLA - Installation - Manual (Page 10)

ISSUED: 08-15-07 SHEET #: 055-9491-8 07-15-11
Visit the Peerless Web Site at www.peerlessmounts.com
10 of 13
For customer care call 1-800-865-2112
Cable Management
To make an opening to route cables through
projector mount assembly, adjust projector mount
assembly to full upward tilt position by turning
knob for tilt adjustment as shown in fi gure 8.2.
Left or right roll position can be adjusted if more
space is required.
NOTE: Be certain tamper resistant screws are not
engaged before making adjustments (see step 9).
Route cables through top of extension column as
shown in fi gure 8.1 and fi gure 8.2.
NOTE: A method for assisting cables through
extension column may be required (example:
string tied to connector to help pull through
extension column).
Route cables through projector mount assembly
as shown in fi gure 8.2 and connect to projector.
8
DO NOT
CRIMP
WIRES
BEND WIRES OF RCA
PLUGS IN OPPOSITE
DIRECTION
NOTE: INNER DIAMETER OF
EXTENSION COLUMN MAY NOT
ALLOW PASSAGE FOR ALL
CONNECTOR TYPES.
ROUTE
CONNECTOR
THROUGH
FIRST
CABLES WITH COMBINATION
OF VGA CONNECTOR
AND RCA PLUGS
INNER
DIAMETER OF
EXTENSION
COLUMN
CABLE
CONNECTOR
fi g. 8.1
KNOB FOR TILT
ADJUSTMENT
EXTENSION COLUMN
fi g. 8.2
KNOB FOR ROLL
ADJUSTMENT
OPENING
FOR ROUTING
CABLES