Peerless-AV PRG-EXC - Installation - Manual (Page 12)

12 of 14 ISSUED: 04-24-08 SHEET #: 055-9257-8 10-28-13
Visit the Peerless Web Site at www.peerless-av.com For customer care call 1-800-865-2112
IMPORTANT: For security installations, insert one #10-32 x 1/4" socket pin screw (E) through projector mount
assembly (A) and into connection block as shown. Tighten screw with 4mm security allen wrench (I).
CONNECTION BLOCK
A
E
9
To adjust yaw (swivel): Loosen two screws indicated below half a turn using allen wrench (I). Align projector to
the desired swivel position and fully tighten screws indicated.
To adjust pitch (forward and backward tilt): Turn knob on back of mount as shown below. Pull knob out and
turn by hand for easy adjustment or insert #2 phillips screwdriver in end of knob and turn.
To adjust roll (side to side tilt): Turn knob on side of mount as shown below. Pull knob out and turn by hand for
easy adjustment or insert #2 phillips screwdriver in end of knob and turn.
Projector Alignment
KNOB FOR ROLL
ADJUSTMENT
KNOB FOR PITCH
ADJUSTMENT
BACK OF MOUNT
ARROW INDICATES
FRONT OF MOUNT
20° (±10°) SWIVEL
SWIVEL A D J U S T M E N T
TOP VIEW
SCREWS FOR
SWIVEL ADJUSTMENT
NOTE: For tamper proofi ng of projector alignment, see step 10-1 on page 13.
MOUNT ASSEMBLY
NOT SHOWN FOR
CLARITY
10
• Do not loosen adjustment screws to the point they become disengaged from the mount. Weight of the projector
should be supported in case of accidental disengagement.
WARNING