PowerWalker Inverter 3000 PSW - Manual (Page 15)

12
EN
SPECIFICATIONS
Table 5 Line Mode Specifications
MODEL PowerWalker Inverter 3000 PSW
Input Voltage Waveform Sinusoidal (utility or generator)
Nominal Input Voltage 230Vac
Low Line Disconnect
170Vac±4%(NOR)
90Vac±4%(GEN/WID)
Low Line Re-connect
180Vac±4% (NOR)
100Vac±4% (GEN/WID)
Note:
1.NOR setting can be used for general electrical appliance
2. WID setting can be used only for some special load, such as lamp, fan.
High Line Disconnect 280Vac±4%
High Line Re-connect 270Vac±4%
Max AC Input Voltage 300Vac rms
Nominal Input Frequency 50Hz / 60Hz (Auto detection)
Low Line Frequency Disconnect 40±1Hz
Low Line Frequency
Re-connect
42±1Hz
High Line Frequency Disconnect 65±1Hz
High Line Frequency Re-connect 63±1Hz
Output Voltage Waveform As same as Input Waveform
Output Short Circuit Protection 30A Circuit Breaker
Efficiency (Line Mode) >95% ( Rated R load, battery full charged )
Transfer Switch Rating 30A
Transfer Time
10ms (typical) 15ms max(NOR)
20ms (typical) 40ms max(GEN/WID)
Bypass charger enable in off mode Yes
Power Limitation