Pace-Edwards BL Dodge with RamBox - Manual (Page 3)

STEP 2: INSTALL WIRING HARNESS
(If the optional wire harness Part# BL1120 is used, you may want to tape it to the main
harness to ease having to pull them through the stake pocket separately).
From inside the truck bed push the long wire harness end without the plug through the stake
pocket on the drivers side of the truck and out the underside of the truck bed box.
Leave approximately one foot of slack inside the box for mounting the electronics.
Route the wire harness under the truck and to the battery in the engine compartment.
Attach the fuse holder to the end of the Red/positive wire.
(Do not attach to the battery yet.)
Secure the harness with wire ties provided after slack from the canister has been taken out.
INSTALLATION INSTRUCTIONS 3
HARDWARE USED:
WIRE HARNESS x 1
ZIP TIES x 5
STEP 3: INSTALLING RAILS
Open the rail box along the length of
the box; lift rails out to avoid scratching
the rail surface on the package
staples.
REMOVE PROTECTIVE PAPER ON
UNDERSIDE OF RAILS AND RISER
BARS. THIS IS FOR PACKAGING
PURPOSES ONLY.
Rail Grips
Rail
Flange
Ribbed
Blanket
FIG. 2a
Place the riser bar on top
of the OE tie down bars
padded side down.
Riser bar
OE tie down bar
(end cap removed)
HARDWARE USED:
RISER BARS x 2 (LEFT &
RIGHT)
You will need a second person to help lift the canister with the rails attached into the truck
bed. Place one hand under the canister and one hand under the rails and place the whole unit
inside the truck bed. The canister and rails will rest on top of the riser bars.
Slide the entire canister and rail assembly forward against the cab end of the truck bed.
Close the tailgate and pull the rails only toward it leaving approximately 1/8” gap between the
end of the rails and the tailgate.
Be sure to hold the canister in place to ensure it does not move from the front truck bed sill
with the rails while adjusting the gap of the rails to the tailgate.
Attach the strip of foam to the front sill of the truck bed from the left tonneau rail to the right
tonneau rail.
STEP 4: PLACE CANISTER AND RAILS INSIDE THE TRUCK BED
FOAM
Remove the cap on the end of the OE tie down bars (these will
be replaced later).
Place the riser bar padded side down on top of the OE tie down
bars even with the cab side of the truck bed. (there will be
some overhang over the tie down bars) see Figure 2a.
The machined end of the rail attaches to the canister.
You will need to lift the hanging portion of the ribbed blanket
and thread it in the rail while sliding the rail into the rail grip
mounted to the ends of the canister (the underside of the
blanket ribs need to nest on the gear).
Make sure both fl anges of rail slide into the rail grip.
Push the rails forward against the canister.
Complete for both left and right rails.
HARDWARE USED: