Pace-Edwards BL Dodge with RamBox - Manual (Page 2)

Complete Canister
Assembly
Top Cover
Rails
(left & right)
Hardware
Pack
Clamp
Pack
Drain
Tubes
2
Rails Come in a
separate Box.
Note: There should be no drilling into the truck body needed on most standard or full-size trucks .
7/16” wrench or socket
Side Cut Pliers #2 Phillips screwdriver
Tape measure
STEP 1: REMOVE CONTENTS & PLYWOOD PACKAGING
Remove the canister and top cover from the box.
Remove components from inside the canister. Perform a quick inventory to insure all parts are there.
Using the 3/8” wrench or socket remove the 2 bolts holding the plywood packaging supports on the ends of the
canister. Discard plywood packaging supports and bolts.
DISCARD PLYWOOD PACKAGING AND BOLTS!
(Do not let the blanket roll back on itself or the underside on the fi rst three ribs can damage the visual
surface of the other rolled ribs)
.
Remove all of the vinyl sheeting protecting the blanket.
Pull the blanket out about 1 foot from the canister and let it hang.
TOOLS REQUIRED FOR ASSEMBLY:
BEFORE YOU START:
The BedLocker also offers an optional wire harness (part # BL1120) to manually operate the tonneau cover from
inside the cab of your truck.
This harness is designed to plug into the custom-built electronics control box mounted inside the canister.
Thread the plug through the side of the canister and connect it to the grey/violet plug. Make sure to secure the
loose wires inside the canister away from the gear and blanket.
Then run the wire to the cab and attach under the dash in a suitable location.
OPTIONAL WIRING HARNESS FOR DASHBOARD SWITCH:
PACKAGING CONTENTS:
DO NOT USE A KNIFE TO OPEN
THE RAIL BOX.
OPEN THE RAIL BOX ALONG
THE LENGTH OF THE BOX
AND LIFT RAILS OUT TO AVOID
SCRATCHING THE SURFACE OF
THE RAILS ON THE PACKAGE
STAPLES.
CAUTION!
3/8” wrench or socket
BEDLOCKER ® DODGE RAMBOX
Rail Riser
Bars
(left & right)
Read the instructions carefully before you start. Due to the custom fi t of this truck bed cover the installation will
require a second person to help in placing the canister in the truck bed. If you have questions regarding the
installation please call our Technical Support Line at (800) 338-3697.