Pace-Edwards BL Nissan Titan - Manual (Page 5)

INSTALLATION INSTRUCTIONS 5
After checking the between the rail measurement sheet to see how many shims you might
need per side on the front clamp assembly and the tailgate end clamp assembly, take the
Clamp Shims (3) and the Clamp Spacer (4) and fi t them behind the Clamp Rail Grip (1) and
up against the inner bed rail lip.
Thread the Clamp Rail bolt (5) with the Lock Washer (6) and Flat Washer (7) and put it
through the Clamp Rail Grip (1) and thread it into the Rail Grip Block (2). Tighten the bolts
making sure the rails stay level with the truck bed rails as you tighten.
Place the 4 allen screws (8) in the clamp rail grips as indicated in Figure 5a and tighten
them.
Remeasure the distance between the rails at the canister and tailgate. This distance should
be the same to allow your cover to operate properly.
(5) CLAMP RAIL BOLT x 4
(6) LOCK WASHER x 4
(7) FLAT WASHER x 4
(8) ALLEN SCREWS x 4
STEP 5: INSTALLING CLAMPS ON TRUCK WITH UTILI-TRACK
CHANNEL SYSTEM (continued)
HARDWARE USED:
STEP 5: INSTALLING CLAMPS ON TRUCK WITH OUT UTILI-TRACK
CHANNEL SYSTEM
HARDWARE USED:
Before shimming and installing the rail clamps make sure the canister is centered between
the truck bed rails.
Take the Clamp Rail Grips (1) and slide 2 on each rail, 6-12” from the canister and 6-12”
from the tailgate.
With the tailgate closed, slide the rails to establish the correct spacing to the tailgate. The
rails have rubber spacers on the end caps, to establish the correct spacing (1/16”) and to
prevent the tailgate from striking the rails when closing. Make sure the canister stays snug
up against the cab end of the truck bed while establishing correct spacing to the tailgate.
Once the rails are correctly placed open the tailgate.
After checking the between the rail measurement sheet to see how many shims you might
need per side on the front clamp assembly and the tailgate end clamp assembly, take the
Clamp Shims (2) and the Clamp Spacer (3) and fi t them behind the Clamp Rail Grip (1) and
up against the inner bed rail lip.
Thread the Clamp Rail bolt (4) with the Lock Washer (5) and Flat Washer (6) and put it
through the Clamp Rail Grip (1) and thread it into the Clamp Back Plate (7). Tighten the
bolts making sure the rails stay level with the truck bed rails as you tighten.
Place the 4 Allen Screws (8) in the clamp rail grips as indicated in Figure 5a and tighten
them.
Remeasure the distance between the rails at the canister and tailgate. This distance should
be the same to allow your cover to operate properly.
(1) CLAMP RAIL GRIP x 4
(2) CLAMP SHIM x 4
(3) CLAMP SPACER x 4
(4) CLAMP RAIL BOLT x 4
(5 & 6) LOCK & FLAT
WASHERS x 4
(1) CLAMP RAIL GRIP
(7) RAIL BACK PLATE
(2) CLAMP SHIM
(3) CLAMP SPACER
(4, 5 & 6) CLAMP RAIL BOLT, LOCK &
FLAT WASHER
RAIL
TRUCK BED RAIL
(8) ALLEN SCREWS x 4
(8) ALLEN SCREWS
(7) RAIL BACK PLATE x 4
FIG. 5A
WITH OUT
UTILIT-
TRACK
SYSTEM